Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Update on tests....HELP!!! 200 1982

I jumpered the FV relay and verified that the frequency valve was getting 12V at the green wire connector on the FV.

When the wire is jumped and the engine is off, the FV buzzes as it should. Upon starting after about 15 seconds, the FV stops buzzing, but I still have 12V at the connector.

Interestingly enough, if I disconnect the O2 sensor, the FV comes back on and stays on as long as the O2 sensor is disconnected.

The O2 sensor is putting out .95V at idle which decreases as the rpm's increase.

I'm stumped. For some reason, the FV is cutting out even when it has power going to it.

I recently changed out the pcv kit and I'm wondering if I may have damaged the line that goes from the FV around next to the pcv nipple, but the thing does work when the O2 sensor is unplugged. Ugh...

Is it possible that my wiring harness connector has a bad connection? The gray connector's wires don't look too hot and I'm sure I'll have to replace this harness at some point.

Any more ideas?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Frequency valve cuts out after about 15 seconds after starting [200][1982]
posted by  WrenWright  on Sat Jul 15 22:18 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.