Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2016 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Engine harness replacement - no start 200 1986

posted by  spethick on  Mon Aug 28 16:01 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jan 30 11:51 CST 2012
[RELATED]

Thanks! I triple checked everything and looked closely at all the places suggested, it turns out Bob was right; it was simply a matter of moving the spade connector on the starter. Fired right up.

Once again saved by the Brickboard. I can honestly say that I never would have even attempted to change my Oil Separater, let alone decide that this was a good time to change the main harness without knowing this board is here and so very helpful. Really pretty amazing. I'll be sending in my contribution this week.

Thanks again everyone!

Steve
Eugene, Oregon






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Engine harness replacement - no start [200][1986]
posted by  spethick subscriber  on Sun Aug 27 14:22 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.