Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

pulled trans, which seals to replace? 200

posted by  Strong-Pimp-Hand on  Tue May 22 03:06 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Mar 8 12:15 CST 2009
[RELATED]

With the tranny out I replaced:

pan gasket
front pump seal
coverter housing o-ring
tail shaft bushing & seal
od selenoid o-ring
kick down cable
shifter bushings
pinion seal (rear end)

there is also another seal, or two, at the shifter. i did not do those.

you'll probably want to do the tranny mount for posterity as well.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
(http://drevilspinazzz.ytmnd.com)

"Be who you are and say what you feel because those who matter don't mind and those who mind don't matter." -Dr. Seuss






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New pulled trans, which seals to replace? [200]
posted by  volvosfive subscriber  on Tue May 22 02:28 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.