Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2014 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Master Cylinder 140-160

posted by  cef2lion on  Sun Jun 10 16:16 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Jul 9 05:17 CST 2014
[RELATED]

Got the brakes bleed and working. Had a friend stop by. Didn't take much since I must have gotten much of the old flushed out the day before. Did have a small leak on the front right. Tightened fitting going from caliper to brake hose.

I put the switch back in the distribution block. The wire for it had been unplugged. I assume to turn off the dash brake light. Now that I had the brakes back in operation I assumed I could connect the wire. I did but the brake light stayed on. Going to pull that switch and test it. I assume one can do that with an ohm meter.

Craig






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Master Cylinder [140-160]
posted by  cef2lion  on Wed Jun 6 01:02 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.