Volvo RWD S90-V90 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2007 S90-V90 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

95 960 injector ends/seals S90-V90

posted by  someone claiming to be Joska on  Fri Jun 22 03:04 CST 2007 [RELATED]

I'm presently in the middle of replacing my intake manifold gasket, I have the manifold back together, however I still have the injectors to put back in.

I have noticed that on the injector ends that point into the manifold/engine, there is a round plastic 'cap' which appears to clip on to the injector end. I don't really know what these are for, as they leave a large hole on the injector end, however I've noticed that this cap on cylinder 6 injector has cracked.

Are these necessary to retain on the car? Are they supplied as a replacement with the lower O seal? I should renew all the O seals while they are out. I just don't know whether to worry about this plastic part or not.

Thanks






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 95 960 injector ends/seals [S90-V90]
posted by  someone claiming to be Joska  on Fri Jun 22 03:04 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.