Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2002 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

wheel question 120-130

posted by  122_Canadian on  Thu Oct 25 06:20 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Oct 20 07:51 CST 2009
[RELATED]

Hi Chris,

If your positive 40mm and need to get to stock (25mm) then you'll need a 15mm spacer to get the wheel to run on the same centre line as the stock wheel (all wheel measurements are made relative to the centre line of the wheel). The stock wheel runs more wheel to the back side of the mounting surface than the front, but with a 15mm spacer you'll have to get longer studs just to be safe. Removal of the studs is easy and finding new ones is almost as simple, just put a sacrificial lug nut on the stud and give it a "gentle tap" with a 5lb hammer.

Hope this helps.
Craig






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New wheel question [120-130]
posted by  1966-estate  on Wed Oct 24 23:22 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.