Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Wait 200 1983

Look at the model number of the plug. eg. BPR6ES - the R means resistor. A non-resistor would be BP6ES.

The reason I brought the resistance problem up is because I have an '80 240. It was set up for non-resistor plugs. I purchased resistor plugs at the store because that was what the chart recommended for 240s. But the chart didn't take into account the changeover from non-resistor (early 240s) to resistor plugs (later 240s). The charts also were wrong for spark cables. So I had a lot of problems with hesitation and bucking on acceleration.

Check ngk.com, for example and look at the recommended plugs for earlier and later 240s.

It took me awhile to realize that the resistor plugs added an additional resistance (6k?) to the total. Platinum plugs also cause problems. So check the total resistance (cables and plugs) from the coil with an ohmmeter/multimeter. Some cables have resistance/radio suppression (carbon fiber core) others don't (copper core) but have resistor terminals. Mix/add too many resistances together and you (actually I) got problems.
--
1980 245 Canadian B21A with SU carb and M46 trans in Brampton, Ont.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Can issue with spark plugs cause hesitation and misfire or backfire during cold start? [200][1983]
posted by  Schro  on Wed Nov 28 18:54 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.