Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2021

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

O2 sensor socket use w/ 4th gear switch * M46 trans

posted by  Rule 308 on  Fri Dec 14 04:14 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue May 8 09:20 CST 2012
[RELATED]

If it is 7/8-22mm in size it will probably work. 4th gear switches are something that you almost never do, so I don't recall if it was 22 or 24mm. I used to have a deep socket that I ground to just the right length so that you could roll it onto the switch with a breaker bar attached to it and break the switch loose. You can try ordering up the O2 sensor wrench but if it were me I would buy a cheapie socket and cut/grind it to the desired length and be done with it.

Mark






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New O2 sensor socket use w/ 4th gear switch * M46 trans
posted by  transit wind subscriber  on Wed Dec 12 12:47 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.