Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2007 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Have you installed one of these in a 122? 120-130

posted by  Pebee on  Sun Mar 16 02:58 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Jun 21 07:30 CST 2014
[RELATED]

Mine was installed in a 544.
The adjustable arm that the sender and float arm attach to is in 2 pieces to allow for deep tanks, and the sender can be slid up or down to he mid-piont between top and bottom of the tank.
As the 544 tank is only about 6'' deep, I used only the top section, cut off 1/2" for clearance, and positioned the sender and float arm at 3" down. I then attached the wire from the gauge - grounded the flange with a jumper - and adjusted the float arm to match the range of the gas gauge before setting it down into the tank. It should not be necessary to bend the float arm
Pete.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New fuel gauge sending unit [120-130]
posted by  floyd_ramp  on Sat Mar 15 08:23 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.