Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

header pipe bracket attachment..... 200

posted by  Stickbuilder on  Thu May 15 13:40 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 03:31 CST 2014
[RELATED]

The header pipe to the bell housing support actually uses a bolt plate with 2 studs attached to the plate. This bolt plate ties the support to the header pipe, and is secured with 2 flat washers and nuts. The bolt plate goes in from the front, and the nuts and washers are fitted from the rear. If you can find one of these at a scrap yard, it will be easier to maintain a leak free system.

Bill






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New header pipe bracket attachment..... [200]
posted by  jjnuttall  on Thu May 15 10:51 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.