Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2013 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Ignition OBD problem/no start problem. 200 1992

posted by  porkface on  Thu Dec 18 07:53 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 09:12 CST 2014
[RELATED]

does the car have spark? if yes, the the sensor and ignition ecu are ok.

only time i've seen a crank sensor code is when someone dropped the bolt for the sensor into the hole. got another bolt and left the 1st bolt in the bellhousing. eventually, the bolt got into the reluctor on the flywheel and screwed it up-no start. if the sensor goes bad, they don't set codes.

on the pin 6, check the bottom of the socket, could be the wire fell out. good luck, chuck.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Ignition OBD problem/no start problem. [200][1992]
posted by  Bryan.C  on Mon Dec 15 08:22 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.