Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/1998 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

ANSWER Should I replace my tail light circut boards? 200 1989

posted by  TONY H on  Sat Jan 31 10:05 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 16:39 CST 2014
[RELATED]

I would use a regular Pencil eraser on the contact points of your existing Circuit boards.
I would also take the bulbs in and out of the sockets a few times on those corner (brakelight) sockets. it will help clean up a little corrosion that may be adding resistance on one side.
Another secret is to not fully screw the socket back into the circuit board. Let the socket tabs touch a 'new' section of the circuit board.
--
'75 Jeep CJ5 345Hp ChevyPwrd, two motorcycles, '85 Pickup: The '89 Volvo is the newest vehicle I own. it wasn't Volvos safety , it was Longevity that sold me http://home.no.net/ebrox/Tony's%20cars.htm

This post has been marked as an answer to the original question.

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New ANSWERED Should I replace my tail light circut boards? [200][1989]
posted by  CineMan  on Fri Jan 30 18:28 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.