Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2009 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Sub-Frame Connectors 120-130

posted by  ColinSpikes on  Mon Feb 2 14:15 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Jul 28 21:06 CST 2011
[RELATED]

Hi There,

If I do weld in the connectors it wouldn't be in response to a specific handling problem. Instead, the rear passenger floorboards in my 122 are rotten and need to be replaced. My friend (a welder), suggested that I remove the dip in the rear and connect the two frame rails while we're in there. In this approach, we'd connect the c-frame rails and weld in a flat piece a sheet metal on top. I will never race this car and I'm not particularly concerned about moving the rear floor pan up a couple of inches.

Colin






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Sub-Frame Connectors [120-130]
posted by  ColinSpikes  on Sun Feb 1 20:00 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.