Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2004

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Photos Aformentioned

posted by  gopeshs on  Wed Mar 4 12:02 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon May 19 14:01 CST 2014
[RELATED]

That looks very neat and professionally done.Great. Since you are good with hammer ;-) here are couple of new ideas (I am only a dreamer, so I have not done any personally)


Lower braces
check this link

http://www.ipdusa.com/version.asp?strPageHistory=category&numSearchStartRecord=0&strParents=69,265&P_ID=337&CAT_ID=265&V_ID=807

Tower to tower brace:
You could also try a tower to tower brace. I do not know why a simple straight pipe will not work .Some think like this.
http://r31skylineclub.com/wiki_img//sbsbwhiteline.jpg

Ipd's complex design looks like this

http://www.ipdusa.com/version.asp?strPageHistory=category&numSearchStartRecord=0&strParents=69,265&P_ID=337&CAT_ID=265&V_ID=808

You could also try dual sway bars . There used to be a link on turbobricks. Atleast the front one were quite easy to do with minimal $$ and work. Regular sway bar clamps, long bolts and modified end links were needed. I am not able to locate that link somehow.


Regards
Gopesh


--
DD-1990 240 DL SW M47II FI 3.1 234 K miles






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 7 DIY low cost Strut Braces [200][1983]
posted by  Joe Heart  on Wed Mar 4 02:28 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.