Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2004

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Streetside outer tie rod end replacement; adjusting toe in to get it close.

posted by  rstarkie on  Fri Apr 10 07:48 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:14 CST 2014
[RELATED]

I am familiar with the process of adjusting toe in using a tape measure with the car on a flat level floor.

I have only done it after taking a measurement before component replacement. Measure the distance between two points on the tires and then adjusting to that measurement after new components are in place.

In this case my son had an outer tie rod end seperate and I made a street side repair. With no "before" measurments I can't set an "after".

What would be a reasonable difference between a distance of two points on the front edges and a distance between two corresponding points on the back edges of the tires to get a decent toe in setting?

Thanks,

Randy






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Streetside outer tie rod end replacement; adjusting toe in to get it close.
posted by  rstarkie subscriber  on Fri Apr 10 07:48 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.