Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2014 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Replacing Water Temp. Sensor 200

posted by  David Samuels on  Sat May 16 15:05 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 20 12:23 CST 2014
[RELATED]

Charlie, are you changing the sensor for the temp gauge or the ECT sensor for the injection? Though pulling the manifold for the ECT makes it easier (tucked back there under the number three runner), neither sensor absolutely requires it. On the ECT, there is a sealing washer for the seat, so no sealant necessary. On the temp gauge sensor I suggest a little Permatex or one of the sensor safe RTV silicones, though Teflon tape will do in a pinch.

DS






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Replacing Water Temp. Sensor [200]
posted by  dobber13 subscriber  on Sat May 16 14:53 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.