Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Procedure to change out back up/reverse light switch 200 1993

posted by  Robert S. on  Thu Jun 18 15:42 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Sep 21 05:48 CST 2014
[RELATED]

Just completed this job on our '88 245 DL.

Do you have the new switch? I found a good used one from a donor car. The job is done all on the inside of the car. Presume you have an Automatic; the job is outlined below.

- Loosen the gear selector trim panel and move out of the way,
- Then loosen the two screws that mount the switch to the gear selector assembly
- Disconnect the wiring and remove,
- Replace with new switch

The most time consuming part is getting to the four spade wiring connectors under front drivers side carpet. Had to remove the drivers seat and some of the bottom door and console interior trim to free up the carpet enough to get underneath it and reach the wiring connectors.

Good luck, Robert






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Procedure to change out back up/reverse light switch [200][1993]
posted by  mr.zorak subscriber  on Thu Jun 18 07:49 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.