Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2006 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Rust repair - bigger or smaller than a breadbox 120-130

You asked a while back about taking off the front fenders. If you have done so, you will see that the top of the fender sits on a ledge, which is a favorite spot for rust to hide.
Also pop off the 6 or so round plastic plugs, about 3" in diameter, along the inner side of the rocker panel area. Get a penlight and a small adjustable mirror and have a good look in there. Pull the upholstery off the sides panels of the back seat and poke around there as well. You can see into the trunk and down to the rear fender lip with the aforementioned penlight and mirror, another favorite spot. Finally along the back of the trunk area, where the gas filler neck comes in, there is a semi-blind panel with wiring running through it. Again inspect with the penlight and mirror.

Good luck. I'm with Paul. If what you showed us is the worst of it, I would take the shell in a hot minute.

Cheers,
--
Barry -- 1967 122S 'Betty'






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Rust repair - bigger or smaller than a breadbox [120-130]
posted by  tdskip subscriber  on Fri Jul 17 02:31 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.