Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

torque values 200 1987

posted by  sdewolfe on  Sat Jul 18 07:07 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jan 31 05:56 CST 2011
[RELATED]

Howdy,

Applies to oiled nuts/bolts. Use new bolts for torque-to-yield specs.

flywheel: 1st, 45Nm (33ft/lb); 2nd, angle tighten additional 50 degrees
bellhousing: 35-50Nm (26-37ft/lb)
starter motor: Could not find this specification. I would say the same as the bellhousing, 35-50Nm (26-37ft/lb)
clutch plate: 25Nm (18ft/lb)
driveshaft at the tranny: M8, stage 1, diagonally 30Nm (22ft/lb), stage 2, diagonally angle tighten additional 60 degrees
M10, diagonally 50Nm (37ft/lb)
Rubber universal joint, M12 80Nm (59ft/lb)
--
Mr. Shannon DeWolfe -- I've taken to using mister because my name misleads folks on the WWW. I am a 53 year old fat man. ;-)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New torque values [200][1987]
posted by  Andy's banna brick  on Sat Jul 18 06:05 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.