Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2004

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

After installing newer harness is 83 240 it started

Hello again,

Hope all is well.

After installing newer wiring harness is 83 240 it started right up,
after sitting for about a month.

I got out of car to check on engine and noticed that the idle began to
raise, it continued to raise. At the
same time I noticed that the engine block was rocking quite a bit, like
never before. I immediatly shut the car down, but it won't start again.


I tryed to start it up again, but it does not catch, it just turns
and turns.

I checked the fuses, they are fine and I replaced the relays with a good
pair and I continue to have simular issue of no catch.

How can I be sure that the fuel injector wires are correct
on each injector or does it matter?

I cleaned the throttle body while I had the air intake valve off.
The TB was SUPER DIRTY, it had a layer of crust inside, it took 1/2
can of TB cleaner to get it clean.

Thanks in advance,
Joseph






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New After installing newer harness is 83 240 it started
posted by  NewMexico240 subscriber  on Thu Aug 13 07:03 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.