Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2007 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Yikes!!!! 120-130

posted by  Rhys on  Tue Sep 29 05:19 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Nov 20 10:22 CST 2012
[RELATED]

George has it right - the tool uses the external thread as I recall. Never had or used one though.
I also made a bar from heavy angle iron, with two 3/4 inch steel pins welded to it, to restrain the cam gear while tightening. Especially with the fibre gear, it's best not to block the crank gear and depend on the very few teeth engaged in it to hold back the tightening torque. With the steel gears you'll probably be OK.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New B20 cam gear installation question [120-130]
posted by  uncle_bagley subscriber  on Mon Sep 28 15:38 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.