Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2010 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Stalling 240 3-1-1 code 200 1991

uid 27's pic
posted by  Art Benstein on  Wed Feb 3 12:45 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 20:10 CST 2014
[RELATED]

Oh, no. I thought you were asking about repairing the switch. Removing and installing is something I have done a few times, and never through the cluster hole. Just remove the knee bolster and reach up. Feel the large connector socket and wiggle that toward the front of the car (away from you), off of the ignition switch. Then, with small screwdriver in hand, pointed toward you, find the two screws recessed in the ears holding the ignition switch to the lock assembly. Getting the screwdriver in the slot works better with your eyes closed, as the saying goes.
--
Art Benstein near Baltimore

Never miss a good chance to shut up.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Stalling 240 3-1-1 code [200][1991]
posted by  pageda  on Wed Feb 3 10:21 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.