Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2006

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Thermal compound application to ignition amplifier heatsink

posted by  triode52 on  Sat Feb 20 15:57 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 22 09:17 CST 2012
[RELATED]

A paper thin coating of heatsink compound is all that is required since it is just used to fill in surface irregularities. So, from what I read above you did things absolutely right and there should be no real gap between the surfaces once you are done.

Arctic silver 5 compound is normally used in CPU applications where much higher power densities and heat loads are applied. It really is great stuff but also expensive.

Mike






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Thermal compound application to ignition amplifier heatsink
posted by  rstarkie subscriber  on Sat Feb 20 09:16 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.