Volvo RWD 444-544 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2001 444-544 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Using a Bosch 139 Module to run stock point ignition 444-544

posted by  malloy1 on  Wed Feb 2 18:17 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Oct 12 17:44 CST 2014
[RELATED]

Steve-

It should also reduce/eliminate the points from burning because it's low voltage through the points.

Since point gap isn't important to trigger the module, it should reduce/eliminate setting the gap.

The dwell control of the 139 Module should help out too.

I found this information too:

http://www.dinoplex.org/PDF/Wiring_Ferrari_Dino_246_Bosch.pdf


Photobucket

Not sure if the additional circuit is needed, but I might just set it up to see if it makes a different.

Paul






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Using a Bosch 139 Module to run stock point ignition [444-544]
posted by  malloy1  on Fri Jan 28 20:40 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.