Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2008 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

timig Gear 140-160

posted by  walrus3 on  Fri Aug 26 09:46 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Dec 2 14:20 CST 2013
[RELATED]

I made a puller out of a piece of half-inch plywood and 3 3/8" carriage bolts with the heads ground eccentric so they would fit through the holes and then move to one side and pull. I started out with a 7/16"-14 bolt in the center to push with, and eventually put a T-nut in to give better bite than the wood.
It does not take much of a pull. The shaft is straight, not tapered and it is about a zero-interference fit.
Like the others I would bet that it is the gear itself. They get loose on the knurled steel hub and get VERY noisy. The noise usually disappears under load, until the wear gets so bad that the gear can slip on the hub.
--
George Downs Bartlesville, Oklahoma






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New timig Gear [140-160]
posted by  rawits  on Thu Aug 25 17:22 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.