Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2012 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Drive train not aligned in the tunnel. 200

posted by  Andrew in AL on  Thu Nov 17 18:21 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 06:17 CST 2014
[RELATED]

This thread cost my attention as I have just replaced the passenger side mt and the tranny mount on my 92 245.

Two things you might consider.
I have been told (and it was true in my case) that the passenger side will go well before the drivers side.

If you can't get your fingers in between the oil filter and the right side mount ..it is way too low.

And three ...I may be about to change my mounts again ...with OEM mounts. I am getting a buzz through the dash, and I am a bit concerned it could be the aftermarket parts I bought from Europarts. It may be an alignment issue with me too ...just have to figure it out.

I wish you well.
--
"Do you think that's air you're breathing now'? (The Matrix 1999) '89 764 (retired), '94 940T (319K), 92 245 (207K)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Drive train not aligned in the tunnel. [200]
posted by  transit wind subscriber  on Mon Nov 14 00:55 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.