Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2002

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Parts that are needed when replacing aTDO4H-13C

posted by  vacuumhead on  Fri Nov 25 23:27 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Oct 12 06:49 CST 2014
[RELATED]

Tnankyou for the info. I figured I could get away with making an upper gasket but have no idea what to expect where it enters the block. From your inference it wouldn't be wise to try to use the lower O-ring. Is that a part I can buy separately at a dealer? Or perhaps would it be possible to match one up .






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Parts that are needed when replacing aTDO4H-13C
posted by  vacuumhead  on Fri Nov 25 16:58 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.