Volvo RWD 1800 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 5/2008 1800 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

removing gauges 1800

posted by  MrBob on  Sun Dec 18 19:08 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Feb 4 12:53 CST 2012
[RELATED]

Adding to Chris' explanation; when removing the temp gauges I first remove the throttle lever between the gas pedal and linkage at the firewall to make room for the probe to pull through the hole without stressing the very vulnerable tubes.
This requires a 7/16" socket for the two bolts holding the rod in place, one on each side of the heater box, and a 5/8" open end for the probes.
Bob
66S






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New removing gauges [1800]
posted by  eckloffe  on Tue Dec 13 20:24 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.