Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Anyone use the HF Press for Control Arm Bushing? 200 1990

posted by  1990Volvo240 on  Wed Mar 14 13:41 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 3 13:18 CST 2014
[RELATED]

Hi,

I have been planning on doing some front suspension work and I need to replace the rear control arm bushings (the ones that are pressed in the bracket).

I have used the HF 20 ton Press and a 3/4" drive metric socket set (as pushers/receivers) for most bushings, but from looking at the Bentley manual it seems I am going to have a hurdle due to the shape of the control arm bracket. I figure I won't have enough room for the sockets.

Has anyone used this press to push out those bushings and if so what tips can you offer?

Thanks,
Travis






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New ANSWERED Anyone use the HF Press for Control Arm Bushing? [200][1990]
posted by  1990Volvo240 subscriber  on Wed Mar 14 13:41 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.