Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

control arm bushing procedure - why wheels touching in Bentley's 200 1993

posted by  someone claiming to be adirondack blues on  Thu Jun 7 19:21 CST 2012 [RELATED]

No clue why it says this. Support car on jack stands and remove wheels. Unbolt everything and they come right off. Use Don Foster's "lay the control arm and bucket/bracket flat on the floor" method for the re-install and you don't need to torque the rear bushing while on the car. Don's method gets the control arm very close to neutral alignment.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New control arm bushing procedure - why wheels touching in Bentley's [200][1993]
posted by  someone claiming to be Robb McC  on Wed Jun 6 15:43 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.