Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2025 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Drive Shaft Center Bearing replacement - where do I seat a bearing puller? 200 1988

posted by  tbb2 on  Fri Feb 15 15:26 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Jul 16 18:57 CST 2014
[RELATED]

I am looking to replace the Drive Shaft Center Bearing.

I inherited a bearing puller that has a point to press against the center of the drive shaft. But the information I see indicates that the rear portion of the drive shaft is splined into the front section leaving a 6"+(?) deep hole.

What does a bearing puller press against?
Is the tool I inherited missing a part?
Is there an accessory that will work with the puller to span the hole?

Is all this just lack of experience and any old piece of flat steel across the end will work?

Thanks
--
1988 244 DL; B230F; LH-2.2; Manual 5-speed






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Drive Shaft Center Bearing replacement - where do I seat a bearing puller? [200][1988]
posted by  tbb2 subscriber  on Fri Feb 15 15:26 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.