Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2000 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Question on codes. Where to start looking 200 1992

posted by  JimSig on  Tue Aug 13 12:09 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Mar 28 17:24 CST 2014
[RELATED]

Did you get all three of these codes from socket 2, or did the 142 come from socket 6?

Make sure the fuse is good to the o2 sensor. If it is, you can easily test the o2 sensor with a voltmeter. Peel back the rubber insulation on the single wire that is attached to it along the firewall (leaving it connnected) and probe the connector with the + probe with the - probe connected to ground. You should see the voltage sway up and down between .3 and .8 volts if the sensor is good - if it doesn't sway it needs to be replaced.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Question on codes. Where to start looking [200][1992]
posted by  Xraybob  on Mon Aug 12 17:52 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.