Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2006 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Cruise Failure: Speedometer is at Fault 900 1995

Cruise control is managed by an computer up under the driver's footwell. When the cruise in my son's 95 940 failed, I performed the diagnostics thanks to the OBD unit under the hood. It returned "no signal from speedometer". The speedometer and odometer were working fine. I tested the output from the speedo using a multimeter and it "appeared" to be working. After making sure everything else was working, I finally replaced the speedometer and cruise returned to normal.
It so happens that the speedometer receives a sine wave signal from the rear axle sending unit and converts this into a square wave, with frequency proportional to rear wheel velocity, to serve as a the input into the cruise control computer. If this does not happen, no cruise control. I do not have an oscilloscope which would have made quick work of this diagnostic.
Anyway, if your cruise dies and you get this diagnostic report while your speedometer appears to be working fine, consider that the internal wave conversion might have failed. This means a replacement speedo.
--
See the 700/900 "FAQ" at the menu bar top screen left side.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 Cruise Failure: Speedometer is at Fault [900][1995]
posted by  Steve subscriber  on Sun Dec 8 18:26 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.