Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 3/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Crank Position Sensor 200

posted by  Amarin on  Sat Oct 25 10:57 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 22:42 CST 2014
[RELATED]

Hello,

I also recommend OEM or better OE.

If you're really picky about saving some dollars then rewire the CPS. Its just a 3 wire sensor. The sensor itself usually not broken but the wiring is (exposed to heat/vibration and such). You could get such 3 wires with shielding from radio shack/mouser/digikey/farnell or the likes. Solder the new wires between the sensor and its electrical plug. Add some heat insulation around the new wire and you're good to go.

Regards,
Amarin.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Crank Position Sensor [200]
posted by  Sjam subscriber  on Fri Oct 24 20:24 CST 2014 >
  • New Why? ... [200]
    posted by  Ken C subscriber  on Sat Oct 25 10:48 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.