Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Control arm bushing question 200 1985

posted by  Xraybob on  Sun Oct 4 08:51 CST 2015
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 05:32 CST 2014
[RELATED]

Years ago, I replaced the control arm bushings on one of my 240's without tightening the rear nut with the bushing/nut under load. I had just tightened the nut with the arm off the car then just bolted everything up like I had removed it without any issues that I could tell. I did very well for years. I'm not replacing bushings on another 240 and just read somewhere of this load tightening procedure. I there any harm in not doing the load procedure? Thanks in advance.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Control arm bushing question [200][1985]
posted by  Xraybob  on Sun Oct 4 08:51 CST 2015 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.