Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2011 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Screen under vent at wipers 700 1990

uid 55's pic
posted by  john sargent on  Sun Nov 27 16:48 CST 2016
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 22 09:07 CST 2014
[RELATED]

Just three screws hold the cowl vent in place. One on each side where it meets the fenders, and one in the center. The one in the center is about three inches down, it also has a 10mm head. It should be a two person job to remove and re-install the cowl vent. The hood needs to be open 45 to 90 degrees. Pull the cowl vent forward and carefully work it out from under the hood. Re-installation is the same, be sure the cowl vent slips under the plastic retainers at the bottom of the windshield.
--
john






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Screen under vent at wipers [700][1990]
posted by  Andrew in AL subscriber  on Tue Nov 8 20:10 CST 2016 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.