Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2020 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Turn signal problem 200 1989

posted by  jwalker on  Wed Oct 4 11:06 CST 2017
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Jun 6 08:39 CST 2014
[RELATED]



You received some good suggestions already. As previously mentioned, if the car is a sedan, it could be the rear circuit board. That would be my guess as I had a similar problem with my 90 sedan. You can try cleaning it if they are not too bad. If they are heavily corroded you are probably better off dropping $20 or so and buying a new circuit board for the passenger rear. BTDT...:)

I would take the spraying the switch a step further. Remove the switch. Clean/sand all the grounds. Then spray and reassemble.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Turn signal problem [200][1989]
posted by  alex1366  on Tue Oct 3 19:43 CST 2017 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.