Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Source Identified; Replace only the Brake Failure Light? 200 1988

Think I mentioned this much earlier in this epic thread. In order for the brake fluid level to drop in the reservoir, air has to be able to enter the reservoir. If you examine your reservoir cap carefully, you'll see there is a tiny vent hole -- mine is right in the center of the cap. If you top of the reservoir, screw on the cap and seal that hole with a piece of tape, you can disconnect a line(s) below and virtually no fluid at all will come out. It can't leave the system if air (atmospheric pressure) can't get in the top of the reservoir. Covering the vent hole prevents the air from getting in the top. Exactly like putting a straw into your iced tea, putting your thumb over the top and pulling out a straw-full of tea. When you remove your thumb, out comes the tea.

So taking this approach means you WILL NOT have to re-bleed your MC all over again when you replace/rebuild your brake failure switch.
--
82 242-6.2L; '17 Mazda3; '16 Crosstrek






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Mystery Brake Fluid Leak [200][1988]
posted by  1908242DLa  on Mon Jan 14 14:23 CST 2019 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.