Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2007

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How... do I break in a rebuilt engine? b230 Oil selections?

posted by  Chris Mullet on  Tue Sep 15 06:15 CST 2020
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 09:08 CST 2014
[RELATED]

Once you have filled the oil pump you should probably spin the oil pump for a couple minutes to push all the air out of the oil galleries and to get oil up to the top end. I believe before you install the T-belt that you can just turn the I shaft alone with a drill motor, in it’s normal direction of rotation, to drive the pump. If you car has the side mounted distro then it may need to be installed in order to complete the connection between I-shaft and oil pump. Others on this forum will know for sure.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How... do I break in a rebuilt engine? b230 Oil selections?
posted by  Will740turbo subscriber  on Mon Sep 14 21:59 CST 2020 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.