Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2017 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Driveshaft vibration after all new components except the shaft... 700 1990

posted by  Will740turbo on  Sat Jan 7 01:20 CST 2023
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 22 16:09 CST 2014
[RELATED]

To clarify, so far we have:

New engine and transmission mounts plus used (about 40k miles) KYB Gas-A-Just Shocks on the rear
--Vibration started.
--New universal joints, carrier bearing, and carrier bearing support.
--New metal on metal noise started (failed bearing inside rear end)
--Installed used whole axle
--Still vibrating at particular highway speeds, but only occasionally
--Shaft balanced (some weights are huge, was told the shaft was bent near the splines)
--Vibration different but still definitely present


Ideas
? Bad front struts causing weird angle in the rear pinion
? Bad/worn rear torsion rod bushings (or poorly installed since I did it in a rush and tightened them with the car in the air) causing bad angle on the rear pinion
? Bad tailshaft bushing - lots of oil on the transmission, but seems like it is engine oil and not trans fluid





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Driveshaft vibration after all new components except the shaft... [700][1990]
posted by  Will740turbo subscriber  on Sun Dec 4 03:07 CST 2022 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.