Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

replaced Lambda fuel air with non/lambda 200 78

posted by  someone claiming to be Stan Jones on  Fri Feb 2 06:49 CST 2001 [RELATED]

I just replaced the entire fuel air unit in my son's 242GT w/Lambda with a fuel/air unit from a non-california 77' 242 parts car (plain jane with the EGR setup). The car runs great, but seems to use more fuel than it used to. Do I need to adjust the mixture? Is there anything else I should look for. (I didn't put the EGR valve on the 242GT when I did this - could this affect my mileage? - I assumed that wouldn't hurt anything).

Also - does anyone have a good wiring diagram for an 82 MPG engine? I'm redoing the wiring harness at the firewall and forgot to mark which wire on the "car" side that the "grey" wire on the engine side matches up with - since it appears there isn't a grey wire on the car side. the device it attaches to is a thermal sensor for the Lambda unit, I think, located underneath the thermal time switch).





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New replaced Lambda fuel air with non/lambda [200][78]
posted by  someone claiming to be Stan Jones  on Fri Feb 2 06:49 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.