Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re: Compressor Clutch - How to replace 200 1981

posted by  someone claiming to be L K Tucker on  Thu May 17 08:31 CST 2001 [RELATED]

/// The clutch will make a noise while running if the material is down to metal to metal.

Remove the radiator to get room and to avoid damage if a wrench slips.

You may have trouble with the center bolt removal. The clutch must be held while turnig that bolt. The tool is expensive beacuse it is adjustable for all possible units. Make you own by drilling a metal strip and locking small bolts in two holes to match the spacing on the clutch.

It is possible to use one bent rod or one pin bolt if you use the socket wrench holding the center bolt as you stop or fulcrum. This requires two hands and it is not possible to exert full force using this method.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Compressor Clutch - How to replace [200][1981]
posted by  someone claiming to be Jeff  on Tue May 15 15:54 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.