Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2004 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Re: Installation of Boost Controller 700 1989

posted by  someone claiming to be Robin Roemisch on  Sat Jun 2 15:14 CST 2001 [RELATED]

I've got IPD's 3-Core radiator, gonna put in Evans racing coolant as soon as I can find a place to buy some. The temp needle NEVER goes above halfway on the gauge, even after continuous high speed (heheh) running... I spent most of today at an autocross and after a few runs I was idling in line, and it wasn't running hot at all. I replaced most of the cooling hoses last week too...

I think its ok. Anything specific I should watch out for? 12psi is just a goal, I'm not gonna jump right up to that.

Robin Roemisch

bitjockey@hotmail.com

Asheville, NC

'89 744ti m46 ??psi





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Installation of Boost Controller [700][1989]
posted by  someone claiming to be Robin Roemisch  on Fri Jun 1 08:14 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.