Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2003 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re: Bertone engine mounts 700 1987

posted by  someone claiming to be tberardi on  Tue Oct 16 13:46 CST 2001 [RELATED]

I just replaced both my mounts with the hydraulic type and I jacked the engine up at the point where the transmission meets the engine. Remove the center nut on the mount and loosen the 4 bolts before lifting, then slowly lift up the engine until it clears, remove the loosened bolts and mount, install the new mount and bolts, lower the engine ane reinstall the center nut. Done. Its quite easy and the engine can be pushed around to enter the center bolt. Will take you about 45 minutes to finish it. Good luck. PS: I used anti-seize on all threads - good practice.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Bertone engine mounts [700][1987]
posted by  someone claiming to be Steve  on Tue Oct 16 04:52 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.