Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2002 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Engine Stall Advice 900 1991

posted by  jnorris on  Mon Dec 31 01:55 CST 2001
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

The only time it threw a code was one of the times it cutout on the highway and then restarted on its own. 1-4-3, Knock sensor signal fault. I had that replaced but the problem remained.

No codes have shown up since. Which brings me to another question. Is it possible for something like the RPM sensor or the ignition module to go bad and not set a code, even though there are codes for both of them?

john





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Engine Stall Advice [900][1991]
posted by  jnorris  on Sun Dec 30 09:51 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.