Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2008 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Center Support Bearing 700 1988

posted by  Rludwick on  Mon Mar 4 11:24 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Aug 31 16:10 CST 2013
[RELATED]

If it's the same as on my 240 ( which I believe it should be) a sealed bearing with a rubber(black ring on side ) seal...Yes
If you local parts store has a grease needle to fit on the end of your grease gun , work the end of the needle under the seal toward the middle of the bearing and work in in to a low spot and squeeze grease in until it comes out around the seal. then rotate the bearing and do again in as many spots a possible.The bearing will feel tighter when full. after you fill it up , wipe off the excess.
If no grease needle available( I had to do this last week) Go to a Farm and Feed store and get a large syringe ( 1" + diameter with large plunger grip is good, grease is hard to push) with a large needle( the big ones used for livestock, #16 I think) and squeeze the grease in with that






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Center Support Bearing [700][1988]
posted by  markl  on Mon Mar 4 09:43 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.