Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2007 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Torque sequence and specs--YOU NEED TO CHECK THIS OUT 700 1990

posted by  chris herbst on  Thu Mar 7 03:14 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 20 20:32 CST 2014
[RELATED]

As I recall, the torque is around 110 inch-pounds, but I have never seen anyone tighten by torque on a Volvo valve cover. I mean, I've never seen any professionals tighten by torque. I suppose somewhere there's somebody who does it. Still, the question is the right one to ask, but you don't have to worry about it too much as long as they're torqued evenly--of course. Hand tight with a light turn on a 1/4 inch ratchet is my formula.

Start in the middle like any cover, and tighten in a circle to the outside.

If you put RTV sealant over the bearing caps on the ends of the cover, the potential leaks will be decreased about 90%. The Volvo or Volvo-like gaskets are very forgiving. They just don't leak that much.
--
chris herbst, five volvos.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Torque sequence and specs--YOU NEED TO CHECK THIS OUT [700][1990]
posted by  BenofLaurel  on Thu Mar 7 02:58 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.