I am buying an aftermarket reciever, i hvae one that i was going to install before i found that it was broken... my question is about the fact that the one i have is smaller than the old one, as far as face dimensions goes. How do i mount it without a gap around the face? It also doesnt seem to fit the securing bolt in back, which is a metal piece coming down from the back of the dash to the right front part of the radio (directions are in reference to the car, not radio) i am sure i could figure a solution for that one, because it doesnt have to be pretty, but any thoughts or experience for either would be appreciated (email me please, at morganwheeler@hotmail.com)