Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

replacement engine mountings 200 1986

posted by  B.C. on  Sun Jun 23 17:23 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Mar 28 22:28 CST 2012
[RELATED]

Davey -

I expect you have the AW70 trans, right? The judder on starting might be a trans problem rather than a motor mount problem.

Check the motor mount on the right side by putting your hand around the bottom of the oil filter and testing the clearance down to the motor mount. There should be plent of space for your hand.

I the past I have had a mount so bad (unsuspected after a rear-end collision) that the oil filter was resting on the mount!

On the left side you'll have to do a visual check. BTW - if you do the motor mounts, do the transmission mount soon afterwards.

The job is a DIY job. Check the FAQ's and archives, and the shop manual you have, like Haynes or Bentley.

Good Luck,

Bob

:>)





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New replacement engine mountings [200][1986]
posted by  Davey  on Sun Jun 23 10:05 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.