Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How to jack up and block? 200 1988

posted by  pittroj on  Thu Oct 17 01:55 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 20 07:18 CST 2014
[RELATED]

I have always wondered if these jack points are strong enough to support the weight of the whole car, after all they are made up of only bent sheetmetal. Sure, they can support the weight of one corner of the car as intended for changing tires etc. but the full weight of the car, even though you are spreading it out over four points, I don't know. My question is,I guess is will it do any structural damage to the area around the jack points as it appears to only be welded to and made of sheetmetal. What about seam splitting of the caulk etc. Although the car does flex anyway ehile driving even though you can't feel it. Am I reading too much into this?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How to jack up and block? [200][1988]
posted by  Peter P.  on Wed Oct 16 19:21 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.